Ring Sizer Template printable pdf download

Ring Sizer

To use our Ring Sizer, follow these steps:

1. Print it – make sure to uncheck the “fit to page” option on your print command screen.

2. Cut out the sizer.

3. Make a slot in the sizer by cutting along the dotted line.

4. Roll the sizer into a circle with the numbers on the outside.

5. Insert the end of the tab into the slot.

6. Place the sizer around your finger and pull the tab through the slot until the paper is

snug (tight) around the base of your finger.

7. Read your finger size on the scale.

In this example,

In this example, the

the ring size is 17

ring size is 17 1/2

Tips on Obtaining the Proper Ring Fit:

• Whenever possible, have a Balfour representative measure your finger to verify your ring size.

• Due to size variance between hands, you need to decide on which hand and finger the ring will be worn prior to

ordering the ring.

• Fingers have a tendency to swell and/or shrink as much as a half size depending on time of day, temperature,

and after performing strenuous physical activities. For this reason, we recommend that you have your finger

measured at room temperature and in your most normal state during the day to obtain your most accurate ring

size.

When You Receive Your Ring:

• The ring should easily slide on, but will resist slightly when coming off, even taking 2-3 seconds to get over the

knuckle. This is normal and especially common for men, who typically have larger knuckles.

• Remember different activities and temperatures throughout the day will cause your hands and fingers to

constantly change, so it’s normal to have a ring feel tight sometimes and loose other times.

• If a ring initially seems to be a little too large or too small, we suggest that you wear it for a few weeks to get used

to it before exchanging it for a different size. Wearing your new ring for a few weeks will help you better

determine if an exchange is necessary.

Ring Sizer Template