Printable Ring Sizer Template - Dazzling Rock Jewelry Store
ADVERTISEMENT
1Printable Ring Sizer
*Sizes & dimensions are approximate.
Make sure your printer is set to 100-percent. Do not reduce the print size in your printer ‘page
setup’ area. You can verify that the ring sizer printed correctly by measuring it with a ruler; it should
measure 3 1/2 inches long from "A" to "B".
To open the print dialog box, press CTRL + P for pc or COMMAND +P for mac.
Use a quarter to
Method A: Measure Your Finger
make sure this page
is printed at the
correct size.
1. Cut out the ring sizer.
2. Cut a slit for Slot "A".
3. Wrap the sizer around the finger where the ring will be worn. Make sure the numbers are facing out.
4. Pull the pointed end Tab "B" through Slot "A"until the sizer is snug. Make sure to allow size for your knuckle. If your
knuckle is size in between the two.
5. The number aligned with Slot "A" is your ring size.
6. If the measurement lands between two numbers, your size is a half size.
Example: If your
falls between 5 and 6, your ring size is 5 1/2.
measurement
Sizing Tip: Measure your finger at the beginning of the day to avoid incorrect measurements. More sizing mistakes are
made by ordering rings too large rather than too small.
Read
A
B
Size
Here
3½ Inches
Method B: Measure a Ring that Fits
1. Select a ring that properly fits the intended finger.
2. Place the ring on top of the circle below until the inside edge of the ring matches the outside of the circle.
Comfort Fit Ring Tip: If the ring is a comfort fit design, match circles to the contoured edge of the inner surface of the ring.
Size 4.5
Size 5
Size 5.5
Size 6
Size 6.5
Size 7
Size 7.5
Size 8
14.8 mm
16 mm
16.45 mm
16.9 mm
17.3 mm
17.7 mm
18.2 mm
15.6 mm
Size 11.5
Size 8.5
Size 9
Size 9.5
Size 10
Size 10.5
Size 11
21 mm
19 mm
19.4 mm
18.6 mm
19.9 mm
20.2 mm
20.6 mm
Size 12
Size 12.5
Size 13
21.4 mm
21.8 mm
22.2 mm
ADVERTISEMENT
0 votes
Related Articles
Related forms
Related Categories
Parent category: Life