Honda Certified Pre Owned Vehicles Inspection Checklist Page 2
ADVERTISEMENT
1
2
3Honda Certified Pre-Owned Vehicles
182 Point Inspection Checklist
VIN:_______________________________________
MEETS STANDARDS
MEETS STANDARDS
Front Exterior
Under Hood / Fluids (cont’d)
YES NO NA
YES NO NA
78. Windshield Glass (Cracks, chips, pits, scratches, antenna)..........
130. A/C Condenser (Corrosion and road hazard damage).…....…….…
79. Windshield Wiper Blades / Arms (Condition and operation)…….
131. A/C Compressor (Proper cycling, belt condition and tension).....
80. Hood (Paint finish and quality)……………………..……....…..…..…...….
132. Power Steering (Belt condition, tension, fluid level and leaks)...
81. Honda Emblem (Condition – missing or damaged).…….….…….....
133. Electric Power Steering (Operation)………….…….……..……...…………
82. Grille (Condition)…………………………………….……….……….……………...
134. Differential Fluid (Check level and leaks)…………….…………..……….
83. Front Bumper (Paint finish and quality)……………….……..…….……..
135. Washer Fluid (Check level and Leaks)…………..….….……...……………
84. Front Fenders (Paint finish and quality)…..……………..………………..
Comments: _____________________________________________________
85. Headlights / Lenses (Condition and operation – moisture)….……
_______________________________________________________________
86. Fog Lights / Lenses (Condition and operation)………..….…….………
87. Daytime Running Lights / Lenses (Condition and operation)..……
MEETS STANDARDS
Under Vehicle
YES NO NA
88. Turn Signal Lights / Lenses (Condition and operation)…........…….
89. Front Doors (Paint finish and quality)………..……………………………..
136. Brake Calipers (Evidence of binding, loose bolts and leaks)….….
90. Side Mirrors (Paint finish and quality)……………………….....………….
137. Hydraulic Hose / Line (Cracks, kinks, loose bolts and leaks)….….
91. Roof (Paint finish and quality)……………………………….…..….…………
138. Suspension (Loose bolts, bent / broken control arms)….…..….….
Comments: _____________________________________________________
139. Bushings (Evidence of cracks, wear or damage)…….………..…….…
_______________________________________________________________
140. Universal / CV Joint / Boots / Drive-Shaft (Cracks and leaks)…….
_______________________________________________________________
141. Exhaust System (Leaks, holes, dents, cracks and hangers)....….…
_______________________________________________________________
Comments: _____________________________________________________
MEETS STANDARDS
MEETS STANDARDS
Rear Exterior
Brakes / Wheels / Tires
YES NO NA
YES NO NA
92. Windshield Glass (Cracks, chips, pits, and scratches)..….….....……
Left-Front
93. Windshield Wiper Blade / Arm (Condition and operation)..........
142. Brake Pad/Shoe (Replace if wear is >50% of original thickness)..
94. Trunk/Tail Gate/Hatch (Paint finish, quality – tail gate button)…
143. Rotor (Replace if wear is >50% of original thickness)…..…..…...…
95. Honda Emblems (Condition – missing or damaged)…….……………
Record Measurements Below in Millimeters
96. Brake Lights / Lenses (Condition and operation)....…….….…….…..
97. Tail Lights / Lenses (Condition and operation – moisture)..………
98. Back-Up Lights / Lenses (Condition and operation)………..…………
99. Turn Signal Lights / Lenses (Condition and operation)…..………….
144. Wheel (Check condition, lug nut, torque and valve stem).…....…
100. Emergency Lights / Lenses (Condition and operation)…..…..….….
145. Tire (Uneven wear, minimum tread depth 5/32
nd
across tread
101. Integrated Bed Lights / Lenses (Cond. / operation – Ridgeline)...
width, sidewall cracking / cuts, adjust tire pressure)………...….….
102. License Plate Brackets / Light (Condition and operation)………...
Right-Front
103. Emergency Flashers / Reflectors (Condition and operation)…....
146. Brake Pad/Shoe (Replace if wear is >50% of original thickness)..
104. Back-Up / Parking Sensors (Condition only – front / rear)..….....
147. Rotor (Replace if wear is >50% of original thickness)..……..……...
105. Rear Bumper (Paint finish and quality)………………….…..…….………
Record Measurements Below in Millimeters
106. Rear Fenders / Quarter Panels (Paint finish and quality)……..…..
107. Rear / Sliding Doors (Paint finish and quality)………….….……………
108. Exhaust(s) (Condition – loose or damaged)…..…………….......…..…
109. Fuel Door / Cap (Manual operation, secure cap properly)...….…
148. Wheel (Check condition, lug nut, torque and valve stem)..…...…
Comments: _____________________________________________________
149. Tire (Uneven wear, minimum tread depth 5/32
nd
across tread
_______________________________________________________________
width, sidewall cracking / cuts, adjust tire pressure)……..….….….
_______________________________________________________________
Left-Rear
150. Brake Pad/Shoe (Replace if wear is >50% of original thickness)..
MEETS STANDARDS
151. Rotor / Drum (Replace if wear is >50% of original thickness)..….
Under Hood / Fluids
YES NO NA
Record Measurements Below in Millimeters / Write NA if not applicable
110. Hood Support / Prop Rod (Condition – holds hood up)………….…
111. Hood Support Struts (Hold hood up)……………………..…….…………..
112. Engine Compartment (Condition – must be clean)…..….....……….
113. Engine Valve Train (Excessive or abnormal noise)…………….………
152. Wheel (Check condition, lug nut, torque and valve stem)….....…
114. Engine Mounts (Condition – cracks / tears in the rubber)…..……
153. Tire (Uneven wear, minimum tread depth 5/32
nd
across tread
115. Engine (Condition, operation, fluid level and leaks)………..……….
width, sidewall cracking / cuts, adjust tire pressure)…………....….
116. Transmission Mount (Condition – bracket, rubber bushing)…….
Right-Rear
117. Transmission (Operation – MT or AT, fluid level and leaks).....….
154. Brake Pad/Shoe (Replace if wear is >50% of original thickness)..
118. Clutch Master Cylinder (Operation and leaks).…………………...……
155. Rotor / Drum (Replace if wear is >50% of original thickness)…...
119. Brake Master Cylinder / Booster (Fluid level and leaks)……………
Record Measurements Below in Millimeters / Write NA if not applicable
120. Brake System (Operation and leaks)……………..................…...…….
121. 12-Volt Battery (Condition and load test)………………..……..……….
122. High Voltage Battery (Diagnostic Trouble Codes – DTCs).…..…...
123. Alternator (Belt condition, tension and charge)……….………..…….
156. Wheel (Check condition, lug nut, torque and valve stem)..…...…
124. Water Pump (Noise and leaks)………………….…………………….……….
157. Tire (Uneven wear, minimum tread depth 5/32
nd
across tread
125. Fuel Injectors (Condition – fuel lines and hoses)………….….……….
width, sidewall cracking / cuts, adjust tire pressure)…….…….……
126. Radiator (Leaks and road hazard damage)………….…….…….……….
158. Spare Tire / Tool Kit (Check condition and all tools present)….…
127. Coolant Recovery Tank (Condition, fluid level and leaks)…..…….
Comments: _____________________________________________________
128. Cooling Fan (Operation – run engine until fan turns on)…………..
_______________________________________________________________
129. Coolant Hoses (Condition and leaks)……….………….….…..…..………
_______________________________________________________________
Distribution: Sales (White) Service (Yellow) Customer (Pink)
4/15
Item # UC012
2 of 3
ADVERTISEMENT
0 votes
Related Articles
Related forms
Related Categories
Parent category: Business