Ring Sizing Chart
ADVERTISEMENT
1Ring Sizing Chart
Important: Read Before Printing
The accuracy of your measurement depends on printing this sheet in the proper size.
Make sure your printer is set to 100-percent. Do not reduce the print size in your printer
‘page setup’ area. You can verify that the ring sizer printed correctly by measuring it
with a ruler; it should measure 3 1/2 inches long from "A" to "B".
Method A: Measure Your Finger
1. Cut out the ring sizer.
2. Cut a slit for Slot "A".
3. Wrap the sizer around the finger here the ring will be worn. Make sure the numbers
are facing out.
EXAMPLE
4. Pull the pointed end Tab "B" through Slot "A" until the sizer is snug. Make sure to allow
size for your knuckle. If your knuckle is larger than the base of your finger, select a size in between
the two.
5. The number aligned with Slot "A" is your ring size.
6. If the measurement lands between two numbers, your size is a half size.
Example: If your measurement falls between 5 and 6, your ring size is 5 1/2.
Sizing tip:
More sizing mistakes are
READ
made by ordering rings
A
B
SIZE
too large rather than too
HERE
small.
3 1/2 inches
Method B: Measure a Ring that Fits
1. Select a ring that properly fits the intended finger
EXAMPLE
2. Place the ring on top of the circle below until the
inside edge of the ring matches the outside of the circle.
size 5.5
size 5.5
size 5.5
16.0mm
16.0mm
16.0mm
Comfort Fit Ring Tip:
If the ring is a comfort fit design, match circles to the
Too Small
Your Size
Too Big
contoured edge of the inner surface of the ring.
size 4.5
size 5
size 5.5
size 6
size 6.5
size 7
size 7.5
size 8
14.8mm
15.6mm
16.0mm
16.45mm
16.9mm
17.3mm
17.7mm
18.2mm
size 8.5
size 9
size 9.5
size 10
size 10.5
size 11
size 11.5
size 12
18.6mm
19.0mm
19.4mm
19.9mm
20.2mm
20.6mm
21.0mm
21.4mm
size 12.5
size 13
size 13.5
size 14
size 14.5
size 15
21.8mm
22.2mm
22.61mm
23.01mm
23.42mm
23.83mm
ADVERTISEMENT
0 votes
Related Articles
Related forms
Related Categories
Parent category: Life