PERMIT # __________
LOT: __________ BLOCK: __________
In the checklist below, AB and I stand for the air barrier and insulation inspection components to be verified. The local code official will always verify the I
components. In the case where the local code official is not verifying the AB components, they may be verified by a person independent of the insulation
or by the use of a blower door test.
If the permit holder has elected use of a blower door test, documentation of test results verifying air leakage less than 3 air changes per hour when tested per ASTM E 779
or ASTM E 1827 and reported at a pressure of 0.2 w.g. (50 Pa) shall be submitted with this checklist. A passing test demonstrates that the AB components are verifi
Floors (including above-garage and cantilevered floors)
Insulation is installed to maintain permanent contact with underside of
Air barrier is installed at any exposed edge of insulation.
Rim joists include an air barrier.
Rim joists are insulated.
Corners and headers are insulated.
Junction of foundation and sill plate is sealed.
Insulation is permanently attached to walls.
Exposed earth in unvented crawl spaces is covered with Class I vapor
retarder with overlapping joints taped.
Space between window/door jambs and framing is sealed.
Air sealing is provided between the garage and conditioned spaces.
Insulation is placed between outside and pipes. Batt insulation is cut to
fit around wiring and plumbing, or sprayed/blown insulation extends
behind piping and wiring.
Showers and tubs on exterior walls have insulation.
Showers and tubs on exterior walls have an air barrier separating them
from the exterior wall.
Air barrier extends behind boxes or air sealed-type boxes are installed.
box on exterior
Space between sklylight framing is sealed.
U.C.C. F392-1 (12/15)