Louise Douglas Ring Sizing Guide
ADVERTISEMENT
1Ring Sizing Guide
1. Print this page. Use 100% scaling in printer settings (or “page setup” area).
2. Measure the line below with a ruler. It should be exactly 10 cm long.
10 cm
3. If you have a ring that fits your intended finger, place it on the nearest matching circle below.
Match the inside edge of the ring to the circle. Use the larger size if between two circles.
how to find your ring size
Extra Small
Small
Medium
Large
Extra Large
L
M
O
Q
S
K
N
P
R
5.5
6
7
8
9
8.5
5
6.5
7.5
4. If you don’t have a suitable ring, cut out the ring sizer below.
READ
A
B
SIZE
HERE
• Cut a slit for slot “A”.
3 1/2 INCHES
• Wrap the sizer around your finger where the ring will be worn. (Numbers facing out.)
8.89 CM
• Pull tab “B” through slot “A” until sizer is snug. Allow size for the knuckle.
• The number aligned with slot “A” is your ring size.
Match this number to the ring size chart (circles) above.
!
If the measurement lies between two numbers, use a half size.
!
Example: if the measurement is between 6 and 7, use 6.5.
Tips
Before you print:
• Comfortable fit. Your ring should fit comfortably: snug enough so that it won’t fall off; loose enough to
In order to print the ring sizer above, be sure that your printer is set to 100%.
slide over your knuckle with some resistance.
Make sure that you have not reduced the print size in your printer "page setup" area.
• Temperature. Don’t measure when your body temperature is too cold or too hot. A cold finger shrinks;
You can verify that the sizer printed correctly by measuring it with a ruler; it should measure 3 1/2
and a hot finger expands. Measure when fingers are at room temperature.
inches long from point A to B
• Knuckles. Big knuckles affect your ring size. If your knuckle is a lot larger than the base of your finger,
measure the base of your finger and your knuckle – then select a size in between.
• Wide bands. A wider band requires a bigger size. If you’re purchasing a wide band, move up a half size
from your measurement.
1. Cut out the ring sizer
• Smaller or larger? If you hesitate between two sizes, always go with the larger one.
2. Cut a slit for Slot "A"
3.
4. Pull the pointed end Tab “B” through Slot "A" until the sizer is snug, making sure to allow size
ADVERTISEMENT
0 votes
Related Articles
Related forms
Related Categories
Parent category: Life