Property Report Checklist Supplement Template (Page 5 of 8) in pdf

47) _____ Main and distribution panels- Observe and report on panel locations and conditions.

48) _____ Service amperage/voltage- Report on the service amperage and voltage rating.

49) _____ Branch circuit conductors- Observe and report on condition.

50) _____ Aluminum branch circuit wiring*- Observe when present and report on condition and provide

recommendations to correct, monitor or evaluate by appropriate persons to customer when non stranded

aluminum wire is present.

51) _____ Compatibility- Observe and report on condition (e.g., report when breakers or fuses are oversized). It is

not acceptable to report the panels as simply satisfactory to address compatibility.

52) _____ Lights, switches- Observe and report on operation and condition of a representative number (may be

reported in electrical section or individual room description areas).

53) _____ Receptacles, polarity, ground- Observe and report on operation and condition of a representative number

(may be reported in electrical section or individual room description areas).

54) _____ Ground fault circuit interrupters- Observe and report on operation and condition of all existing GFCI

devices.

9.0 Heating

55) _____ Heating equipment- Observe and report on type (e.g., heat pump, forced air gas, etc.) and condition.

56) _____ Energy source- Observe and report on type (e.g., gas or electric).

57) _____ Operating controls (thermostat - Observe and report on operation and condition.

58) _____ Automatic safety controls- Observe and report on presence and visible condition (e.g., limit switches,

thermocouple, etc. on gas units and over current protection on electric units).

59) _____ Chimneys, flues and vents- Observe and report on condition (required if dwelling has a gas heater - report

on flues and vents as well as combustion air ventilation).

60) _____ Solid fuel heating devices*- Observe and report on type (e.g., fireplace, wood stove, pellet stove) and

condition.

61) _____ Distribution system- Observe and report on type and condition. (radiator ducts, etc.) - not required to

describe materials).

62) _____ Air filters- Observe and report on condition. It is not acceptable to describe the filter condition as simply

“present” or “in place”.

63) _____ Heat source- Observe and report on heat source presence in each room (report must contain a reference

to heating source presence in each room) - may be reported in individual room description areas.

10.0 Cooling

Note: If the heating and cooling systems have shared components (i.e., thermostat, distribution system,

filters, registers, etc.) these components may be reported in either the heating or cooling sections.

64) _____ Cooling equipment- Observe and report on type (e.g., heat pump, air conditioner, evaporative cooler) and

condition.

Approved: December 5, 2012

Property Report Checklist Supplement Template Page 5