Lockout/tagout (Control Of Hazardous Energy) - Sample Lockout Procedures Page 8
ADVERTISEMENT
1
2
3
4
5
6
7
8
9
10Sample Lockout Procedure
Step 6 (Continue)
_____________________________________________________________
_____________________________________________________________
_____________________________________________________________
List above any actions necessary to prevent stored energy from reaccumulating to a hazardous level.
For additional information, see Protect employees from the hazards of stored and
residual energy, WAC 296-803-50025, in this chapter.
Make sure the equipment is disconnected from the energy sources,
Step 7:
and stored and residual energy has been made safe. Check that no
employees are exposed, and then verify the isolation of the equipment by
doing the following:
_____________________________________________________________
_____________________________________________________________
_____________________________________________________________
List above the method of verifying machine or equipment isolation, such as operating the push button
or other normal operating controls or by testing to make certain the equipment will not operate. For
additional information, see Verify that the machine or equipment is safe before starting
work, WAC 296-803-50030 in this chapter.
CAUTION:
Return the operating controls to the safe, neutral, or off position, after verifying the equipment is
isolated from its energy sources.
1 • 8 0 0 • 4 B E S A F E
( 1 • 8 0 0 • 4 2 3 • 7 2 3 3 )
R-8
11/04
ADVERTISEMENT
0 votes
Related Articles
Related forms
Related Categories
Parent category: Life