Lockout/tagout (Control Of Hazardous Energy) - Sample Lockout Procedures Page 9
ADVERTISEMENT
1
2
3
4
5
6
7
8
9
10Sample Lockout Procedure
Use with Lockout/Tagout (Control of Hazardous Energy), Chapter 296-803 WAC
THE MACHINE OR EQUIPMENT IS NOW LOCKED OUT:
•
Restore the machine or equipment to service after the service or maintenance
is completed and the machine or equipment is ready to return to it’s normal
operating condition by following these steps:
Check the machine or equipment and the immediate area around
Step 1:
it to make sure all nonessential items have been removed and that
the machine or equipment is in operating condition and ready to
energize.
Make sure all employees are safely positioned for starting or
Step 2:
energizing the machine or equipment.
Verify that the controls are in neutral.
Step 3:
Remove the lockout devices and reenergize the machine or
Step 4:
equipment.
Note:
You may need to re-energize the machine before you can safely remove some forms of
energy blocking.
Notify affected employees that the service or maintenance is
Step 5:
completed and the machine or equipment is ready to use.
For additional information, see Meet these requirements when removing lockout or tagout
devices and energizing the machine or equipment, WAC 296-803-50035, in this chapter.
h t t p : / / w w w . l n i . w a . g o v /
R-9
11/04
ADVERTISEMENT
0 votes
Related Articles
Related forms
Related Categories
Parent category: Life