Master Agreement For Transportation By Motor Carrier Page 16
ADVERTISEMENT
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16B. All Other Rates. For all other rates, the following formula will be used to determine the
applicable surcharge, which will be calculated based on mileage between origin city and
destination city as set forth in Rand McNally MileMaker (Household Goods miles) most recent
version.
(Reported Fuel Price On-Highway Diesel National Average minus 1.199) divided by 5.5 =
$ per mile surcharge
C. Short Haul Fuel Surcharge applies on shipments less than 30 miles. For short haul rates the
following formula will be used to determine the applicable surcharge which will be calculated
based on mileage between origin and destination as set forth in Rand McNally MileMaker
(Household Goods miles) most recent version.
(Reported Fuel Price On-Highway Diesel National Average minus 1.199) multiplied by 0.4 =
$ per mile surcharge.
2. Applicable Accessorial Charges.
Only accessorial charges specified herein will be paid by
ArcelorMittal.
a) Stop Off Charge $75.00 Per Stop as specified below:
i)
Charge will be paid for pickups at two different buildings within the same origin plant.
ii) Charge will be paid for 2-door pickups within the same building.
iii) Charges will be paid for stop-offs in transit at intermediate point or points prior to delivery at
final destination.
b) Diversion or Reconsignment Charge: $75.00 plus out of route miles at $1.00 per mile. All miles
will be calculated using Rand McNally Mile Maker (HHG miles) most recent version.
c) Re-Delivery Charge: $75.00
d) Detention only applies if driver is detained at an ArcelorMittal facility: 2 total free hours per
stop in transit, then $75.00 per hour, in 15 minute increments provided driver waits over 7.5
minutes of each successive quarter hour.
e) Equipment Ordered But Not Used: $75.00
f)
In addition, if a heavy single coil or over-dimensional plate load requires a permit to move,
ArcelorMittal will reimburse the Carrier for the permit. Carrier must provide a copy of the valid
permit in order to be reimbursed.
g) If a load requires escort, ArcelorMittal will reimburse the Carrier if approved in advance, and
with valid cost documentation.
h) For shipments of Over-Dimensional Plate, the following charges will apply:
OVER WIDTH:
% of Applicable Rates To Be Assessed
Over 8’6” to 9’
110%
Over 9’ to 9’6”
120%
Over 9’6” to 10’
130%
Over 10’ to 12’
140%
Over 12’ to 14’
150%
Over 14’
200%
OVER LENGTH:
Over 50’ to 60’
130%
Over 60’ to 65’
150%
Over 65’ to 70’
160%
Over 70’ to 80’
200%
Over 80’
250%
May 2015
Page 16 of 16
ADVERTISEMENT
0 votes
Related Articles
Related forms
Related Categories
Parent category: Business